Evergo poc manual

Flow Meter Knob Be sure oxygen is flowing through the cannula. If it is not, refer to theTioubleshootine Guidc in this manual. Put on the cannula as directed by your home care provider. S rhen you are not using the oxygen concenrrarot press the power switch to the Off [O] www.

The EverGo portable oxygen concentrator by Philips Respironics features an 8 hour battery life and can be taken anywhere you need to go at a moment's notice.

Add that, combined with the EverFlo, a small and lightweight stationary concentrator, you'll have a system that meets your every travel, home, and portable oxygen need. The EverGo Portable Oxygen Concentrator from Respironics is the oxygen therapy solution that lets you do the things you want to do - whether it's jumping on a plane, going for a walk on the beach, playing a round of golf, or just going to the store - without worrying about running out of oxygen.

The EverGo's 8-hour average battery life, The EverGo Portable Oxygen Concentrator from Respironics is the oxygen therapy solution that lets active patients do the things they want- without worrying about running out of oxygen.

Warnings A warning represents the possibility of harm to the operator or patient. Where the prescribing health care professional has determined that an interruption in the Unauthorized service could cause injury, invalidate the warranty, or result in costly damage.

Discontinue use and replace if damaged. DO NOT immerse the device in any fluids. Always make sure filters and other openings in the case are not obstructed by items which may impede ventilation. Do not place the device in a small closed space such as a closet. Do not allow the device to be connected to the auto adapter outlet while starting the automobile normally or while you are starting the automobile with battery recharging cables.

Wait until the automobile starts before connecting the device to the DC power outlet. Secure the device securely when used in any moving vehicle. The same cautions apply if using the DC adapter outlet on a boat or recreational vehicle. The device should not be operated without the battery s installed. If the device is Page 9: Symbol Key Caution! Page Getting Started 12 hours 6 hours 8 hours 4 hours 6 hours 3 hours 4 hours 2 hours 4 hours 2 hours 4 hours 2 hours Table 1.

Approximate duration of the EverGo device operating with two or one fully charged batteries. To insert the battery s correctly, follow these steps. Place your device in a well ventilated location. Note: The EverGo device is shipped from the factory with the battery s removed. Caution: Open the carrying case only when EverGo is turned off. Never open the case while the unit is operating.

Page 12 Philips Respironics logo faces the inside Figure 3. Inserting the primary of the device. Pull back the plastic battery. The fan will run the entire time it is charging to keep the battery s cool. When charging is complete this takes a minimum of four hours for first use , disconnect the AC Power Supply and store it with the AC Power Cord for future use.

Note: Replacement and spare batteries are available separately. For information, contact your homecare provider or see the EverGo web site at www. If you are not yet breathing through the cannula, EverGo will begin to pulse automatically about once every five seconds. As soon as you begin breathing through the cannula, the device will begin delivering pulses based on your breathing.

Back up breathing occurs only when the EverGo unit has not detected a breath for 30 seconds. You may begin breathing from the EverGo at any time.

Page Getting Started Note: A standard single lumen nasal connected to the oxygen outlet port cannula and tubing not supplied should on top.

The device works with cannula tubing up to 30 ft. To turn on the device, gently touch the screen shown in Figure 8. This first touch brings Page 17 EverGo User Manual 4. Each time you press the flow setting number, an up arrow Figure 9. Touch the number to change the flow setting. Examples are shown in Figures To increase the flow setting, press the up arrow.

To decrease the flow setting, press the down arrow. Warning: It is very important to set your device to your prescribed level of oxygen flow. Page Operating The Touch Screen 1, and that the primary battery is inserted and fully charged. Because there is no symbol for the secondary battery on the left, this means the secondary battery is not inserted. After you turn on the EverGo, it should take less than ten minutes to reach the specifi ed oxygen purity levels.

It is safe to begin breathing from the EverGo device immediately. Breathing from the unit will cause it to reach oxygen purity It appears whenever you take a breath and the unit delivers a pulse of oxygen. This screen shows a flow setting of 1. The primary battery is inserted correctly and fully charged, and the secondary battery is inserted correctly and fully charged.